Okayo UHF-PLL EJ-701DR-PLUS User Manual page 12

Wireless Handheld Mic EJ-701TS+/EJ-701TM+
Operation and Setting
Turn-on / Turn-off
1. Press Power Switch key "
show "On" first and then show channel number and battery life indicator after 1 2
seconds. The LED Power Indicator will be light on in blue as well.
2. Under any situation, the unit can be turned off if pressing Power Switch key
for more than 2 seconds.
Setting of Channel
After turning on the unit, the current channel
Press "Frequency Set" key (5) for more than 2 seconds until the channel number
starts to blink, and then press "Up" or "Down" key (5) to select the channel
from 1-96. Press "Frequency Set" key (3) again to confirm the setting of channel
number or it will return back to the original channel number after 10 seconds without
pressing any key.
Frequency Pairing
1. After turning on the unit, the frequency pairing will be run automatically once.
2. The LED Power Indicator will be light on blinkingly in blue for three times and
then constantly while frequency pairing successfully.
3. Press Frequency Set key for less than "
function again. If frequency pairing unsuccessfully after turning-on for 20 seconds,
it will back to the original channel number with LED Power Indicator light on in blue
constantly and the original channel number remained without blinking.
4. The distance for frequency pairing should be less than meters.
Notice: This function is available while only working with DR-501A.
The performance of signal transmission is highly involved with
battery energy. Batteries with 1600 mAh (or above) in capacity
are recommended. The optional charger HDC-702 is an economy
solution for you daily use.
CAUTION!!
DO NOT attempt to charge Alkaline battery. It will lead to battery
leakage or even explosion!
Take out batteries when the devices won't be operated in a long time.
" (7) for second to turn on the unit. The LCD window will 1
"
10
"
is shown on the LCD window.
2 seconds to enable frequency pairing
3
~
" (7)
HDC-702