Gas Connection - Venini VGH64 Instructions And Installation User Manual

5) GAS CONNECTION

The gas connection is located in the rear and on the
underside of the appliance 100 mm from the right
hand side.
A. The cooktop can be connected with rigid pipe as
specified in AS5601 table 3.1.
B. If installing with a hose assembly, install with a
hose assembly that complies with AS/ANZ 1869
(AGA Approved), 10mm ID, class B or D, no more
than 1.2m long and in accordance with AS5601.
Ensure that the hose does not contact the hot
surfaces of the cooktop, oven, dishwasher or any
other appliance that may be installed underneath or
next to the cooktop. The hose should not be
subjected to abrasion, kinking or permanent
deformation and should be able to be inspected
along its entire length with the cooktop in the
installed position.
Unions compatible with the hose fittings must be
used and all connections tested for gas leaks.
Natural Gas
Natural Gas installations require the connection of
a gas regulator at the appliance.
Assemble the regulator (noting the gas flow
direction) and transition pieces (supplied with the
appliance), in accordance with figure 12.
The transition piece on the supply side of the
regulator must be provided by the installer.
INSTALLATION
IMPORTANT:
a perfect installation, adjustment or
transformation of the cooktop to use other
gases requires a QUALIFIED INSTALLER: a
failure to follow this rule will void the
warranty.
FIG. 11
Liquified Petroleum Gas
In a LPG installation the gas regulation is made at
the gas cylinder and regulation at the appliance is
not required. To connect supply to the appliance
use transition pieces as shown in figure 12. These
pieces are supplied with the appliance on
purchase.
WARNING:
THE BURNER FLAME MUST BE ADJUSTED BY
THE INSTALLER.
FAULTY INSTALLATION WILL NOT BE
COVERED UNDER WARRANTY.
THE APPLIANCE IS FACTORY SET FOR
NATURAL GAS. THE TEST POINT PRESSURE
SHOULD BE ADJUSTED TO 1.00kPa WITH THE
WOK BURNER OPERATING AT MAXIMUM.
8
FIG. 12