For Best Cleaning Results; How The Cycle Works - KitchenAid KGRT500 Use And Care Manual

U
sing the Self-Cleaning Cycle
To stop the self-cleaning cycle at
any time:

For best cleaning results

•
After the oven cools to room tempera-
ture, wipe up any residue or ash with a
damp cloth or sponge. If any spots remain,
clean with a mild abrasive cleanser or
cleaning sponge.
•
Clean the oven before it gets heavily
soiled. Cleaning a very soiled oven takes
longer and results in more smoke than
usual.

How the cycle works

The Self-Cleaning cycle uses very high heat
to burn away soil and grease. During the
cycle, the oven gets much hotter than it does
for normal baking or broiling. This high heat
breaks up the soil or grease and burns it
away.
Your oven is preset for a 3
Cleaning cycle. However, you can adjust the
cycle time to the amount of soil in your oven.
You can set the cycle anywhere between 2
and 4 1 ⁄ hours. (See "Setting the controls"
2
earlier in this section.)
The graph at the right is representative of
1
a normal, 3 ⁄ -hour Self-Cleaning cycle. Note
2
that the heating stops after 3 hours, but it
takes longer for the oven to cool enough
to unlock the door.
50
1 ⁄ -hour Self-
2
1 ⁄
2
PRESS
CANCEL
OFF
•
If the Self-Cleaning cycle does not get
the oven as clean as you expected, the
cycle may not have been set long enough
or you may not have prepared the oven
properly. Set the Self-Cleaning cycle
longer the next time and hand-clean areas
noted in "Before you start" earlier in this
section.
865°F ( 463°C )
CLEANING CYCLE
OVEN SHUT OFF
( normal broiling temperature )
DOOR LOCKS
START 1
Time In Hours
YOU SEE
ON
TEMP PROBE TIMED DELAY
CONTROL CLEAN
O
DOOR LOCKED STOP
F
START ? COOK TIMER
("DOOR LOCKED" will
appear if oven has
not cooled down)
DOOR UNLOCKS
2 3 STOP
O