Using The Management Console - NComputing L-Series User Manual

If you select "Do not use Password", there will be no password required to view or change the access terminal's
settings.
If you select "Protect device Setup Options with Password, a dialog box will pop up where you will be required
to enter a password twice. Then, when users click on the "Setup" button in the "Options" sub-menu, they will be
asked to enter the password. No other menus are affected by this password.
NComputing recommends setting the password to improve security.
The "Update" Tab
Your NComputing L-Series access terminal may at times require a firmware update. To do this, select the
"Update" tab and click on the "Update" button. When the access terminal asks you for a password, enter
"updateme" (without the quotes). Your access terminal will walk you through the process of updating the
firmware.
It is crucially important that you follow the instructions. If you turn off the access terminal during the firmware
update process, it may become non-functional.
After the firmware update process is complete, reset the access terminal by turning it off and on.
Certain changes in the terminal services software require a firmware update in each access terminal connected to
it. NComputing notifies customers when a firmware update is required by a given terminal services software
update.
The "Misc" Tab (L200 only)
The "Misc" tab contains settings that are no longer supported.

Using the management console

Start the management console from the Windows Start menu. The application is called, "NCT-2000-XP
Console"You can also start the management console by right-clicking on the NComputing icon in the system
tray and selecting "NCT-2000-XP Management Console".
23