Fcc Information - NComputing L-Series User Manual

NComputing would like to thank you for purchasing this product.
2005-2007 NComputing, Inc. All rights reserved. Specifications subject to change without notice.
©
NComputing® is the property of NComputing and may be registered in Korea and other countries.
Other trademarks and trade names are the property of their respective owners.
Refer to the following to prevent any physical injury or loss of assets caused by damage to the product.
A user must read this User's Guide carefully before use and follow the instructions.
• Please make sure that the place of installation is not too hot (above 35˚C) ,too cold (below
0˚C), or too wet.
• Please keep the case safe from any severe impact.
• Please make sure that the product does not come into direct contact with benzene or thinner.
• Please make sure that the product is not exposed to direct sunlight or any hot machinery.
• Please keep the product away from any items which have strong magnetic properties.
• Please do not disassemble, repair or rebuild the product.
• Please do not leave a LAN (Local Area Network) cable in any passageway. An electric shock,
fire, damage to the product or physical injury may occur as a result of tripping over the cable.
• Please disconnect the LAN cable from the product when the cable is not in use for a long period
of time.
•
Please install the product so it is safe from damage caused by dropping or falling.

FCC Information

This equipment has been tested and found to comply with the limit for a class B digital device,
pursuant 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed
and used in accordance with the instruction, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try and correct the interference by one or
the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected
• Consult the dealer or an experienced radio TV technician for help
Change or modification not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment
2