Connect The Access Terminal; Before; After; Network Connection - NComputing L-Series User Manual

At the "NCT-2000-XP successfully installed" screen, select whether or not to restart the computer.
Note: It is required to reboot the computer before using the terminal service software or the access terminals
connected to the host PC

Connect the Access Terminal

The access terminal must be connected via Ethernet to the host PC. This can be done using an Ethernet switch, a
router, or some other network connection method.
When registering the software, all the access terminals must be connected to the host PC using Ethernet

Network connection

Note: If the network is configured to use DHCP to get dynamic IP addresses, you can setup the access terminal
to use it.
Go to the access terminal and select the "Options" button, then select the "Setup" button.
11