Magnum MD 108T Instruction Manual

Analog fm tuner

Advertisement

Quick Links

Magnum Dynalab MD 108T
ANALOG FM TUNER
INSTRUCTION MANUAL

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MD 108T and is the answer not in the manual?

Questions and answers

Summary of Contents for Magnum MD 108T

  • Page 1 Magnum Dynalab MD 108T ANALOG FM TUNER INSTRUCTION MANUAL...
  • Page 2: Table Of Contents

    - 2 - TABLE OF CONTENTS A MESSAGE FROM THE PRESIDENT............3 UNPACKING YOUR MD 108 T ..............4 CONTROL FUNCTIONS ................5 FRONT PANEL DISPLAY ................6 INSTALLING THE MD 108 T ..............7 REAR PANEL DISPLAY – INPUTS & OUTPUTS..........8 TUNER REMOTE (OPTIONAL)..............
  • Page 3: A Message From The President

    FM listening experience. Call us on our toll free number, 1-800-551-4130 or contact us via email at: info@magnumdynalab.com. We at Magnum Dynalab are here to serve your source audio source needs.
  • Page 4: Unpacking Your Md 108 T

    - 4 - UNPACKING YOUR MD 108 T Carefully inspect all sides of the shipping carton for damage. If there are marks or holes in the carton make note of the location in relation to the unit inside. Any obvious dents or scuff marks should alert you to the possibility of damage. Open the top flaps and carefully lift the transport case out of the carton.
  • Page 5: Control Functions

    - 5 - CONTROL FUNCTIONS The front panel controls consist of the following functions (Each function is clearly Front Panel Display displayed on the illustration on the following page): A. POWER: Controls the power to all display functions. All functions are kept in stand-by mode.
  • Page 6: Front Panel Display

    - 6 - minimize the shadow (the light green area). Use the Magic Eye in conjunction with the signal strength meter to achieve the best response. L. FREQUENCY DISPLAY: Displays the frequency that you are tuned to. FRONT PANEL DISPLAY...
  • Page 7: Installing The Md 108 T

    - 7 - INSTALLING THE MD 108 T 1. Position the tuner the shortest distance from your preamplifier. Avoid putting the unit where there are extremes in temperature. 2. Remove the AC cord from the pouch on the lid of the carrying case and plug it into the AC receptacle at the rear of the unit.
  • Page 8: Rear Panel Display - Inputs & Outputs

    - 8 - REAR PANEL DISPLAY – INPUTS & OUTPUTS INPUTS (Located at rear of unit): The MD 108 has two antenna inputs, labeled A1 and A2. These are controlled by the front panel input selector knob (Knob on left side of front plate). The inputs D1 and D2 are for future use. OUTPUTS (Located at the rear of the unit): The MD 108 T uses high grade XLR connectors for balanced output...
  • Page 9: Tuner Remote (Optional)

    - 9 - TUNER REMOTE (OPTIONAL) If your tuner was ordered with the RC2 “PRECISION REMOTE SYSTEM”, please reference the following operating instructions. 1. The power switch should be off on the front panel of the tuner 2. Using the remote handheld, push the “POWER ON” button. You will see the tuner turn on.
  • Page 10: Image Of Rc2 Remote

    - 10 - IMAGE OF RC2 REMOTE...
  • Page 11: Troubleshooting

    - 11 - TROUBLESHOOTING PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION • Power cord • Connect power cord No sound, meter • Check AC source lights are not on disconnected • Power off at source • Check fuse • Fuse blown • Interconnect not •...
  • Page 12: Reception Techniques

    Magnum Dynalab offers two Yagi antennae, the MD 6 FM or MD 10 FM Vertical ½ Wave - This design offers ease of installation and operation. This type of antenna is omni-directional, which means that it picks up stations coming from all directions.
  • Page 13: Fm Reception Aids And Accessories

    Magnum Dynalab offers the MD ST-2, an excellent vertical ½ wave antenna Folded Di-Pole - This is the most common and simplest of all antennas, most people are familiar with the 79 cent piece of wire you received with most electronics gear (generally provided with a tuner or receiver).
  • Page 14: Product Specifications

    12.8 x 48.3 x 40.7 Weight (lbs./kgs) - 40/17.1 Power consumption (Typ/Max) - 50w/100w Tube Replacement #1,2 6922 MD Cryovalve Reference 6922 #3,4 MD Reference 6922 MAGNUM DYNALAB LTD. RESERVES THE RIGHT TO CHANGE OR MODIFY THE SPECIFICATIONS WITHOUT FURTHER NOTICE.
  • Page 15 - 15 - SAFETY SHEET IMPORTANT SAFETY INSTRUCTIONS 1. KEEP THESE INSTRUCTIONS 2. HEED ALL WARNINGS 3. FOLLOW ALL INSTRUCTIONS 4. DO NOT USE THIS APPARATUS IN WATER 5. CLEAN ONLY WITH DRY CLOTH 6. DO NOT BLOCK ANY VENTILATION OPENINGS, INSTALL IN ACCORDANCE WITH THE MANUFACTURER’S INSTRUCTIONS.
  • Page 16: Limited Warranty

    LIMITED WARRANTY Register your product at www.magnumdynalab.com Magnum Dynalab Ltd. herein referred to as the “manufacturer” guarantees this product to be free of defect in both material and workmanship and agrees to remedy any such defect or replace any defective component at no charge for a period of two years from date of sale to the first end user.

Table of Contents