- 2 - TABLE OF CONTENTS A MESSAGE FROM THE PRESIDENT UNPACKING YOUR MD 90T SETTING UP YOUR MD 90T CONTROLS AND FUNCTIONALITY DISPLAYS AND METERS IMAGE OF MD 90T CHECKING OUT YOUR MD 90T RF-20 TUNER REMOTE CONTROL (OPTIONAL) TROUBLE SHOOTING RECEPTION TECHNIQUES Antenna Cabling:...
- 3 - A Message From the President Thank you for choosing the Magnum Dynalab MD 90T FM Tuner. Great care has been given in the design, manufacturing and selection of components for the MD 90T FM Tuner. This complete process will insure that your listening experience will be optimized for years.
- 4 - UNPACKING YOUR MD 90T Carefully inspect all sides of the shipping carton for damage. If there are marks or holes in the carton make note of the location in relation to the unit inside. Any obvious dents or scuff marks should alert you to the possibility of damage.
Note: Many countries that use 220/230/240 volts have a special FM transmitter, tuning de-emphasis for these countries may be different. Please consult Magnum Dynalab for the correct usage. If your tuner is used in a country where the tuning de-emphasis is set incorrectly the sonic performance will be...
- 6 - CONTROLS AND FUNCTIONALITY (Letters correspond with image on the following page) A. POWER – Turns the power (AC) on and off to your tuner, with the optional remote system this switch must be left in the “OFF” position. B.
- 7 - I. FREQUENCY DISPLAY – Displays the station via a numeric value, the frequency that your tuner is dialed into. Display ranges from 87.5 MHz through 108.5 MHz. This readout is controlled by the tuning knob. IMAGE OF MD 90T...
- 8 - CHECKING OUT YOUR MD 90T 1. Place your power switch to the “ON” position (A on diagram). This should turn on your tuner’s meter lights and frequency display. 2. Place your STEREO/MONO switch (B on diagram) to the Stereo setting. 3.
8. TO RECALL THE NUMBER PUSH THE BUTTON BESIDE PRE AND THEN THE TWO DIGIT LOCATION 9. TO TURN THE UNIT OFF PUSH THE PAGE UP BUTTON AND THEN THE OFF BUTTON Magnum Dynalab Ltd. Local: 905-791- 8 Strathearn Ave. Unit #9 5888...
- 10 - PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION Power cord Connect power cord No sound, meter lights are not on disconnected Check AC source Power off at source No sound, meter Interconnect not Verify installation of interconnects lights are on ...
Magnum Dynalab offers two Yagi antennae, the MD 6 FM or MD 10 FM Vertical ½ Wave - This design offers ease of installation and operation. This type of antenna is omni-directional, which means that it picks up stations coming from all directions.
Should you encounter a situation in which you require more gain to the FM signal or situations where you may need less gain AND better selectivity then the Magnum Dynalab 205 “Signal Sleuth” may be of benefit to you. The 205 is a FM signal processor/amplifier designed specifically for FM. If you would like more information on this item, please feel free to contact us at any time.
(min) 270 mA Anode current (1) (max) 1.07 mA (min) 0.92 mA Anode current (2) (max) 1.07 mA (min) 0.92 mA Total harmonic distortion < 1.8% MAGNUM DYNALAB LTD. RESERVES THE RIGHT TO CHANGE OR MODIFY THE SPECIFICATIONS WITHOUT FURTHER NOTICE...
- 14 - SAFETY SHEET IMPORTANT SAFETY INSTRUCTIONS KEEP THESE INSTRUCTIONS HEED ALL WARNINGS FOLLOW ALL INSTRUCTIONS DO NOT USE THIS APPARATUS IN WATER CLEAN ONLY WITH DRY CLOTH DO NOT BLOCK ANY VENTILATION OPENINGS, INSTALL IN ACCORDANCE WITH THE MANUFACTURER’S INSTRUCTIONS. DO NOT INSTALL NEAR ANY HEAT SOURCES SUCH AS RADIATORS, HEAT REGISTERS, STOVES, OR OTHER APPARATUS (INCLUDING AMPLIFIERS) THAT PRODUCE HEAT.
LIMITED WARRANTY Register your product at www.magnumdynalab.com Magnum Dynalab Ltd. herein referred to as the “manufacturer” guarantees this product to be free of defect in both material and workmanship and agrees to remedy any such defect or replace any defective component at no charge for a period of two years from date of sale to the first end user.
Need help?
Do you have a question about the MD 90T SE and is the answer not in the manual?
Questions and answers