Inserting A Cac Or Piv Card; Battery; Reader Error Massages - baiMobile 3000MP User Manual

Bluetooth smart card reader
Hide thumbs Also See for 3000MP:
Table of Contents

Advertisement

Inserting a CAC or PIV card

As noted above, the reader does not have a power on or off button. Inserting a smart card
into your reader will power on the reader. Removing the smart card will power off the reader.
NOTE: When used in the Bluetooth mode, the reader's radio functions are only enabled when
your smart card is firmly inserted into the reader as shown below.

Battery

Your reader contains a removable, rechargeable battery. This battery is a custom battery,
built specifically for the baiMobile 3000MP Reader. In the event that your reader's battery no
longer holds a charge, please contact
support@baimobile.com
for a replacement battery.

Reader Error Massages

"NO CARD!"
This is displayed when the reader is powered-on without any card inserted. This can happen
if the user uses the 'OK' button to cause power-on without a card inserted or if they plug-in
the charger to the reader without the card inserted. This indication is displayed for a few
seconds before the reader will turn itself off.
"BAD CARD"
It is displayed while the reader is powering-on with a card inserted but the reader was unable
to get the card to return an ATR (Answer To Reset) after causing card Reset. This indication
is displayed for a few seconds before the reader will turn itself off.
"LOW BATT"
It is displayed during power-on if the battery is detected as having very little power remaining.
Once the reader is finished powering-on (booting), this indication is replaced with normal LCD
indicators. This indication can only be displayed as a result of the booting self checks. We
don't quantify this threshold value in any way since it may be adjusted in the future.
14

Advertisement

Table of Contents
loading

Table of Contents