Powering Off The Reader; Charging The Reader; Upgrading The Reader Firmware - baiMobile 3000MP User Manual

Powering off the Reader

Your reader will automatically power off if any of the following occur:
 Your smart card is removed from your reader
 The reader's battery runs out
 The reader times out (a configurable setting)
When the reader is powered off, nothing will be displayed in the LED panel.

Charging the Reader

Your charging cable separates into a plug end and a mini-USB cable. You may charge your
reader using the charging cable plugged into an electrical wall outlet or use just the mini-USB
portion of the charging cable to connect between your reader and a USB port on a computer.
It is recommended that the reader be charged whenever the battery status icon on the reader
indicates that the reader battery level is less than 20%. The reader should be charged from
an AC power source using the supplied charger and cable. A red LED on the bottom of the
reader will illuminate indicating that the reader is charging. Once the red LED is no longer
illuminated, the battery is fully charged and the charging source should then be removed from
the reader.
During charging, a red LED on the bottom of your reader will indicate that the battery is being
charged. When the red LED turns off, your reader battery is fully charged.
NOTE: Most smartphone charging cables with a mini-USB-a connector will also charge your
reader.

Upgrading the Reader Firmware

11