3b – Wall mounting the thermostat
Remove the front panel of the thermostat by
squeezing the buttons on both sides and sliding
it up and off the backplate.
Once you've found a suitable location, fix the
backplate to the wall using the appropriate fixings.
The backplate is designed for size 6 screws.
Be careful to avoid any cables and pipes that
may be buried in the wall.
Note: the backplate is designed to mount
directly onto a single gang back box, if available.
3c – Confirming the hub
is ready to connect
Before inserting the batteries into the thermostat,
check the hub is flashing amber – this means
it's ready to connect. If it is displaying a solid
amber light, simply turn it off then on, and then
switch the receiver and boiler off and then on
again too. The hub should then begin to flash
amber and be ready to connect.
13