Delfi DelfiScan C51 Programming Manual page 48

PROGRAM
Family Code Selection P.C
SS
Replacer Control
MS
MS
SS
1st Replacement
DS
SS
2nd Replacement
DS
SS
3rd Replacement
DS
The Data Replacer is used to edit the scanned raw data prior to transmitting the data to the host computers or terminals. It allows you to select
desired bar code symbologies for replacer control, and provides Multiple Position Replcement in the identified position.
All data must conform to the Identified Bar Code Symbologies, and one to three Identified Characters in the identified position While the Data
Replacer is enabled, it arranges only scanned data without Preamble, Postamble, STX, ETX, Data Length, Prefix/Suffix Symbology ID or Record
Suffix.
Regarding the "Bar Code Selection" and "Position Calculation" of Data Replacer, please refer to page 46
for details.
Please note that all "Character" input should be referred to the ASCII/HEX Table listed in Appendix to find mathced HEX value.
Configure Your DelfiScan
Condensed DataWizard
Data Replacer Setting
Parameter Selection
Disable
Select one bar code symbology
Select all bar code symbologies
Disable
Enable
2-digits identified position; 1 replacement character
Disable
Enable
2-digits identified position; 1 replacement character
Disable
Enable
2-digits identified position; 1 replacement character
44
M_DEFAULT
Option Code 2nd Option Code
FIN
(2 digits) automatic termination
00 automatic termination
FIN
(2 digits) [00-7F]
position
FIN
(2 digits) [00-7F]
position
FIN
(2 digits) [00-7F]
position