Summary of Contents for Jacobsen Groom Master II 88008
Page 1
4130278-Rev B 1 - I N C L U D E S I T E M S 3 - 1 6 Parts & Maintenance Manual Groom Master II™ Sand Trap Rake 88008, Kubota D662-E, 3WD 88009, Briggs & Stratton Vanguard, 3WD...
4. Order by the quantity desired, the part number, paint must be prepaid. code, and description of the part as given in the parts list. Use of other than Jacobsen authorized parts will void the warranty. Table of Contents Safety Maintenance Operating Safety ........
Page 3
Suggested Stocking Guide To Keep your Equipment fully operational and productive, maintain a stock of the more commonly used maintenance items. We have included part numbers for additional support materials and training aids. A more complete listing of accessories and attachments can be found in the Specifications Section. Service Parts Qty.
Watch out for traffic when crossing or the job. Only use accessories and attachments operating on or near roads. approved by Jacobsen. 19. Local regulations may restrict the age of the operator. Stay alert for holes in the terrain and other hidden hazards.
By following all instructions in this manual, you will prolong the life of your machine and maintain its maximum efficiency. Adjustments and maintenance should always be performed by a qualified technician. If additional information or service is needed, contact your Authorized Jacobsen Dealer who is kept informed of the latest Use of other than original or authorized methods to service this equipment and can provide prompt and efficient service.
SPECIFICATIONS SPECIFICATIONS PRODUCT IDENTIFICATION_________________________________________________ 88008......Groom Master II 3-WD Tractor, 18.5 hp diesel engine. ® 88009......Groom Master II 3-WD Tractor, 18 A Textron Company hp gasoline engine. CHARLOTTE, NC MADE IN U.S.A. 2004 YEAR OF Serial Number ....An identification plate, like the one PRODUCTION: shown, listing the serial number, is 88008...
ACCESSORIES & SUPPORT LITERATURE _____________________________________ Contact your area Jacobsen Dealer for a complete listing of accessories and attachments. CAUTION Use of other than Jacobsen authorized parts and accessories may cause personal injury or damage to the equipment and will void the warranty Accesories Support Literature Air Blow Gun ............JAC5098...
ADJUSTMENTS ADJUSTMENTS GENERAL________________________________________________________________ adjustment cannot be made, contact an authorized WARNING Jacobsen Dealer. 2. Replace, adjust, worn damaged To prevent injury, lower implements to the ground, components. disengage all drives, engage parking brake, stop engine and remove key from ignition switch before 3.
ADJUSTMENTS NEUTRAL ADJUSTMENT (GAS UNITS) ________________________________________ 1. Allow engine and hydraulic system to reach normal operating temperature. Move unit to a flat and level surface. 2. With engine running at full throttle, and traction pedal in neutral, release parking brake. Unit should not “creep”...
ADJUSTMENTS PARKING / SERVICE BRAKE ________________________________________________ Inspect brakes pads: Before returning unit to operation, drive tractor in a flat, whenever wheels are removed, open area and check operation of brakes to make sure if tractor creeps on hills with parking brake applied, they are operating correctly.
All torque values included in these charts are approximate and are for reference only. Use of these torque values is at your sole risk. Jacobsen is not responsible for any loss, claim, or damage arising from the use of these charts.
Refer to Section 5. and Engine Manual for specific efficiently at the preset governor setting. Do not change the maintenance intervals. engine governor settings or overspeed the engine. During the break-in period, Jacobsen recommends the following: Diesel Engine: During the first 50 hours of operation, a new engine should be allowed to reach an operating temperature of at least 140°F (60°C) prior to operation at full load.
MAINTENANCE ENGINE OIL ______________________________________________________________ Check the engine oil at the start of each day, before starting the engine. If the oil level is low, remove oil filler cap and add Diesel Engine Dipstick oil as required. Diesel Engine: Perform initial oil change after first 50 hours of operation and Safe Operating Range every 75 hours thereafter.
MAINTENANCE GAS ENGINE AIR FILTER ___________________________________________________ Remove and service the foam pre-cleaner every 25 hours. Replace if dirty or damaged. To service pre-cleaner, wash in a liquid detergent and water. Squeeze dry in a clean cloth. Saturate in clean engine oil and squeeze out excess oil in a clean, absorbent cloth.
MAINTENANCE BATTERY ________________________________________________________________ Make absolutely certain the ignition switch is “Off” and the Verify battery polarity before connecting or disconnecting the battery cables. key has been removed before servicing the battery. When installing the battery, always assemble the RED, CAUTION positive (+) battery cable first and the ground, BLACK, negative (-) cable last.
Remove drain plug from bottom of main tank and loosen or remove breather cap. Check and clean the breather cap, replace as necessary. After oil has drained install drain plug and fill with Jacobsen Hydraulic oil. Purge air from system.
If the Interlock System does not function properly and CAUTION the problem cannot be corrected, contact an authorized Jacobsen Dealer. Always turn the ignition switch off and remove the Keep the wire harness and all individual wires away negative battery cable (Black) before inspecting or from moving parts to prevent damage.
CAUTION If you have to add coolant more than once a month, or add more than one quart at a time, have a authorized Jacobsen Do not pour cold water into a hot radiator. Do not Dealer check the cooling system.
MAINTENANCE 4.20 STORAGE ________________________________________________________________ General Gas Engine - For engine protection Jacobsen recommends the use of a fuel additive such as STABIL ®. Mix additive Wash the tractor thoroughly and lubricate. Repair and following instructions on container. Run engine for a short paint damaged or exposed metal.
TROUBLESHOOTING TROUBLESHOOTING GENERAL________________________________________________________________ The troubleshooting chart below lists basic problems that may occur during start-up and operation. For more detailed information regarding the hydraulic and electrical systems contact your area Jacobsen Dealer. Symptoms Possible Causes Action Engine will not start.
** Or every two years whichever comes first. - Engine Oil - See Section 4.3 III - Use Jacobsen hydraulic fluid: Capacity: 5 gallons *** Inspect visible hoses and tubes for leaks or oil marks. (19 Liters). Order Part No. 5003103 for 5 gal. (19 liter), pail.
GROOM MASTER SAND TRAP RAKE Serial No. All 1.1 Decals WARNING OPERATING IN STRUCTIONS READ M ANUAL BEFORE OP ERATING. MANUALS AVAILABLE FROM: JACOBSEN/TEXTRON, CH ARLOTTE, NC. TO START TO D RIVE/TRANSPORT TO RAKE To prevent burns, do not touch 1. Parking Brake... On.
Page 25
6. Keep bystanders away Item Part No. Qty. Description Serial Numbers/Notes 339237 Decal, Warning (Heat) 3004320 Decal, Patents 4124791 Decal, Jacobsen 4131222 Decal, Instruction Gas Units 4131221 Decal, Instruction Diesel Units 4131329 Decal, Instruction - Spanish Gas Units 4131328 Decal, Instruction - Spanish...
GROOM MASTER SAND TRAP RAKE Serial No. All 2.1 Rear Cover 10 11 USED ON GAS VERSION ONLY...
Page 27
GROOM MASTER SAND TRAP RAKE Item Part No. Qty. Description Serial Numbers/Notes 4124563 Rear Cover Includes Decals • Screen, Hood, Rear-Left • Screen, Hood, Rear-Right • Pivot, Rear Cover 4114552 Panel, Left Side Body 4119745 Panel, Right Side Body - Diesel 4129504 Panel, Right Side Body - Gas 306414...
GROOM MASTER SAND TRAP RAKE Serial No. All 4.1 Left/Right Hood Assembly...
Page 31
GROOM MASTER SAND TRAP RAKE Item Part No. Qty. Description Serial Numbers/Notes 4125545 Left Hood Assembly Includes decals 400108 Screw, 1/4-20 X 3/4 Hex Head 821427 Washer, Sealing 1/4 4125546 Right Hood Assembly Includes decals 404018 Screw, 1/4-20 X 3/4 Truss Head 821427 Washer, Sealing 1/4 306450...
GROOM MASTER SAND TRAP RAKE Serial No. All 7.1 Traction Control GAS ONLY 4 REF 15 REF 16 REF View rotated 180 degrees for clarity View rotated 180 degrees for clarity...
Page 37
GROOM MASTER SAND TRAP RAKE Item Part No. Qty. Description Serial Numbers/Notes 827284 Tread, Pedal 4136013 Pedal Assembly, Control 827326 Pin, Clevis 3/8 X 4-3/16” 830137 Bracket, Control Pedal Mounting 800254 Lockwasher, 3/8” Heavy 306450 Screw, 5/16-18 X 3/4 Hex Head 306325 Lockwasher, 5/16”...
GROOM MASTER SAND TRAP RAKE Serial No. 88009 - All 16.1 Guard Assembly Gas Units Item Part No. Qty. Description Serial Numbers/Notes 891581 Guard Assembly, Belt Drive-Gas 838368 Decal, Belt Idler 838488 Decal, Warning 838314 Latch, Idler Arm 817119 Spring, Extension 400108 Screw, 1/4-20 X 3/4”...
GROOM MASTER SAND TRAP RAKE Serial No. 88009 - All 17.1 Gas Engine Exhaust Gas Units Item Part No. Qty. Description Serial Numbers/Notes 4132175 Engine, 18 HP Vanguard 838237 Bracket, Muffler Support-Gas Engine 4135764 Muffler Assembly 400184 Screw, 5/16-18 X 3/4” Hex Head 453009 Flat Washer, 5/16”...
GROOM MASTER SAND TRAP RAKE Serial No. All 18.1 Air Cleaner Gas and Diesel Engines Diesel Units Units Item Part No. Qty. Description Serial Numbers/Notes 1001121 Air Cleaner Assembly 5000913 • Element, Air Cleaner 5000912 • Cover 5000914 • Valve 3008573 Bracket, Mounting 4133053...
GROOM MASTER SAND TRAP RAKE Serial No. All 23.1 Hydraulic Drive Circuit Install Item 4 with flow arrow pointing up. Gas Unit Hose Routing Install Item 4 with flow arrow pointing down. Diesel Unit Hose Routing...
Page 65
GROOM MASTER SAND TRAP RAKE Item Part No. Qty. Description Serial Numbers/Notes 339985 Connector, Straight Thread 838026 Adapter, 45° Elbow 340144 Tee, Branch 894730 Valve Assembly, Check 4130003 Hose, Upper Bypass to Front Motor 4130004 Hose, Lower Bypass to Front Motor 4130008 Hose, Motor Tee to Upper Bypass 4130316...
GROOM MASTER SAND TRAP RAKE Serial No. All 27.1 Electrical Harness Gas Units 25 25 A - To Headlamp Connector B - To Oil Switch C - To Rectifier/Magneto Anti-Fire Solenoid D - To Neutral Switch E - To Starter F - To Main Harness Ground G - To Seat Switch Connector H - To Park Brake Connector...
GROOM MASTER SAND TRAP RAKE Serial No. All 28.1 Electrical Harness Diesel Units 25 19 A - To Headlamp Connector B - To Oil Switch C - To Fuel Solenoid D - To Neutral Switch E - To Starter F - To Main Harness Ground G - To Seat Switch Connector H - To Park Brake Connector J - To Temperature Sensor...
GROOM MASTER SAND TRAP RAKE Reference Part Item Description Serial Numbers/Notes Illustration Number B-1 See 27.1, 28.1 148074 Battery CB-1 See 27.1 361439 80 Amp Circuit Breaker Gas Units CB-1 See 28.1 361439 50 Amp Circuit Breaker Diesel Units See 27.1 4126082 Shut Down Relay Gas Units...
GROOM MASTER SAND TRAP RAKE 32.1 Hydraulic Schematic Steering Cylinder 3.30 Steering Valve Ports A and B for Optional Blade Lift Accessory Ports C and D for Optional Scarifier Lift Accessory Out Aux Rake Lift Cylinder Lift Valve Return 70-150 15.9 0.91 0.33...
Page 86
Equipment from Jacobsen is built to exacting standards ensured by ISO 9001 and ISO 14001 registration at all of our manufacturing locations. A worldwide dealer network and factory trained technicians backed by Textron Parts Xpress provide reliable, high-quality product support.
Need help?
Do you have a question about the Groom Master II 88008 and is the answer not in the manual?
Questions and answers