Sanyo PLC-WXU3ST Owner's Manual page 25

AUTO PC button
Press the AUTO PC button on the remote control to
operate the Auto PC function. For more detail, see
page 29.
D .ZOOM buttons
Press the D.ZOOM buttons on the remote control to
zoom in or zoom out the images. For more detail, see
page 35.
NO SHOW button
Press the NO SHOW button on the remote control to
black out the image. To restore to normal, press the
NO SHOW button again or press any other button.
When a projected image is captured and set as "User"
in the Logo selection (p.44), the screen changes each
time you press the NO SHOW button as follows.
black out  the captured image  normal 
KEySTONE button
For detail, see page 23.
IMAGE button
Press the IMAGE button on the remote control to select
a desired image level of the screen. For more detail,
see pages 32 and 39.
P-TIMER button
Press the P-TIMER button on the remote control. The
timer display "00 : 00" appears on the screen and the
timer starts to count time (00 : 00 ~ 59 : 59).
To stop the P-Timer, press the P-TIMER button. Press
the P-TIMER button again, then the P-timer display
disappears.
LAMP CONTROL button
Press the LAMP CONTROL button on the remote
control to select the lamp mode for changing the
brightness of the screen.
Auto . . . . . brightness according with the input
signal
High . . . . . Brighter than the Normal mode.
Normal . . . normal brightness
Eco ........... lower brightness reduces the lamp
power consumption and extends the
lamp life.
Remote Control
VOLUME +/- buttons
(See p.24.)
D .ZOOM buttons

Note:
See the previous page for the other
buttons.
• • • • •
The message disappears after 4 seconds.
P-Timer display
Basic Operation
KEySTONE button
(See p.23)
▲▼
POINT buttons
AUTO PC button
IMAGE button
P-TIMER button
NO SHOW button
LAMP CONTROL
button
5