Charging Instructions - Heartway Medical Products P23C User Manual

CHARGING INSTRUCTIONS

To recharge the batteries, follow the steps below:
→Place your power wheelchair close to a standard electrical wall outlet.
→Turn the controller power OFF
→Plug the charger power cord (Round head) into the controller
→Plug the charger power cord into a standard wall outlet. A red and a yellow (if battery charge is low)
LED will illuminate.
→When charging is completed, the yellow LED will turn green.
→Disconnect the charger power cord from the wall outlet when the batteries are fully charged.
Important!
Do not use for voltage input except the specified. Make sure your present voltage input (110V or 220V)
and adjust manually.
Plug-in Controller
Note:
→Always charge your batteries in well ventilated areas.
→The charger is intended for indoor use only. Protect from moisture.
→For maximum performance , it is recommended that you replace both batteries at the same time if
the batteries are weak.
→If the chair will not be used for a long period of time, arrange to have the batteries fully charge for at
least once every month.
According to the battery type and condition of the batteries, batteries usually can be fully charged in
4-10 hours. This will be indicated when the status light in the battery charger side panel turns green.
Charging the battery longer than necessary will not harm the battery. We recommended that you charge
the batteries for 8 to 10 hours after daily use. Do not charge the batteries for more than 24 hours.
Note: There is a battery circuit diagram labeled on the frame. Please refer this diagram before you
assemble the battery.
Plug-in Wall Outlet
16