ADT 4-channel DVR User Manual page 24

User's Manual
NOTE: You will need to get the appropriate Port Numbers for each RAS and WebGuard related program (Admin,
Callback, Watch and Search) from your network administrator.
NOTE: Do NOT use the same port number for two different programs, otherwise, the DVR cannot be connected
with the PC running RAS or WebGuard.
CAUTION: When changing the port settings, you must change the port settings on the PC running
RAS as well. Refer to the RAS manual for details.
NOTE: If the DVR is configured for DHCP or an ADSL network, the IP address of the DVR might change whenever
the unit is turned on.
Highlight the DVRNS tab, and the DVRNS setup screen displays.
16
Change the numbers by highlighting them and using the Up and Down arrow buttons
to increase or decrease the number. The factory default Port settings are:
Remote Admin:
Remote Callback:
Remote Watch:
Remote Search:
Selecting DHCP from the Type and highlighting Save button
reads the current IP address of the DVR configured by DHCP
(Dynamic Host Configuration Protocol) network.
Selecting ADSL (with PPPoE) allows you to set up the ADSL
network.
Highlight the box beside ID and press the
keyboard appears allowing you to enter the ID for ADSL
connection.
Highlight the box beside Password and press the
A virtual keyboard appears allowing you to enter the password
for ADSL connection.
NOTE: Entering the ID and Password and highlighting OK
reads the current IP address of the DVR configured by the
ADSL network.
8200
8201
8016
10019
button. A virtual
button.