Emtek Keypad Deadbolt Locksets Installation & Programming Manual page 11

Keypad Operation - Beeper & LED Indicators
Invalid Code/Access Denied*
Lock-Out Mode Error
Access Accepted
Blackout Battery
Button Press Accepted
Outside Thumb Turn Enabled
* If 3 consecutive incorrect codes are entered, the lock emits 4 short beeps and a flashing Red EMTEK
button. The lock will not accept additional input for 20 seconds (20 beeps).
** Battery voltage has dropped too low; keypad will be disabled but metal key override will still work.
Restoring the Lock to Factory Default Setting
This procedure clears the lock of all users and restores the Programming Code and
2 User Codes shipped with the lock.
• Remove power (disconnect 9V battery) from Lock
• Press and Hold EMTEK button
• While continuing to hold EMTEK button, restore power (reconnect 9V battery)
• Continue to hold EMTEK button for 3 seconds
1 Green LED Flash and 2 short beeps followed by 1 Green LED Flash and 2 short
•
beeps indicates the lock has been successfully restored
IN8-KEYPADDB1
Function
Valid Code
Low Battery
**
Place Sticker Here
Indicators
• 1 short beep, EMTEK button flashes
Green.
• 1 Red LED flash
• 2 short beeps
• 2 short beeps
• 1 short beep per second for duration
• 1 short beep
• 1 Green LED flash
• 4 Red LED flashes
• 4 short beeps
• 1 long Red LED flash
• 4 long beeps
• 1 Yellow LED flash
• 1 Short Beep
• 2 Green LED flashes
09/27/2010
11