oticon minirite Instructions For Use Manual page 30

Safety requirements regarding Direct Audio Input (DAI)
• The safety of hearing instruments with DAI (Direct Audio Input) is determined by the
external signal source. When the DAI is connected to mains-operated equipment, this
equipment must comply with IEC-60065, IEC-60601 or equivalent safety standards.
Wax protection system
• Always visually inspect your hearing instruments to ensure that there is no gap
between the wax protection flange and the tip of the Micro Mold.
If you are in any doubt about the use or replacement of your wax protection system,
contact your Hearing Care Professional.
Warning to hearing instrument dispenser and user
• Special care should be excercised in selecting, fitting and using a hearing instrument
where maximum sound pressure capability exceeds 132 dB SPL (IEC 711) as there may
be risk of impairing the remaining hearing of the hearing instrument user.
• The included case for instrument storage has a built-in magnet. If you have an
implantable device, such as pacemakers or defibrillators, the instrument case should
not be carried in a chest pocket or near to the chest.
Hereby, Oticon A/S declare that this hearing instrument is in compliance with the
essential requirements and other relevant provisions of Directive 1999/5/EC.
Declaration of Conformity is available at:
Oticon A/S
Kongebakken 9
DK-2765 Smørum
Denmark
www.oticon.com
0543 0682
Waste from electronic
equipment must be
handled according to local
regulations. N1175