KitchenAid KBMS1454R Technical Education page 33

b) Remove the two T10 Torx screws from
the door latch assembly (bottom inset).
Actuating Rod
Door Latch Assembly
c) Carefully move the door latch assem-
bly away from the unit just far enough to
release the actuating rod from the pri-
mary and monitor interlock switch holder
(see the top right photo).
Reflected
Image
Door Latch
Assembly Screws
4-7
Lower & Remove
Top Of Actuating
Rod
d) Push the locking tabs and unlock them
from the interlock switch you are servic-
ing, then push up on the switch, and
remove it from the holder.
e) Disconnect the wires from the interlock
switch terminals.
NC
Primary Interlock Sw.
WH & BU
RD
NC
BU
Monitor Interlock Sw.