Table of Contents
Advertisement
(3)
Installation
a) When mounting/dismounting the drive, make sure the vibration and shock requirements of
"2.1.3 Environmental Specification" are met.
b) When removing the spindle motor from the system without stopping it while power is on, pay
special attention to shock in particular until the disk drive completely stops running (about 30
seconds).
(4)
Packaging
a) Store the drive in an antistatic vinyl bag with a desiccant (silica gel).
b) It is recommended to use the same cushions and packages as those at delivery. If those at
delivery cannot be used, use a package with shock absorption so that the drive is free from
direct shocks. In this case, fully protect the PCAs and interface connector so that they are not
damaged.
c) Indicate "This Side Up" and "Handle With Care" on the outside of the package so that it is
not turned over.
(5)
Delivery
a) When delivering the drive, provide packaging and do not turn it over.
b) Minimize the delivery distance after unpacking and avoid shocks and vibrations with
cushions. For the carrying direction at delivery, use one of the mount allowable directions in
Subsection 4.1.2 (vertical direction is recommended).
(6)
Storage
a) Provide vaporproof packaging for storage.
b) The storage environment must satisfy the requirements specified in Subsection 2.1.3 when
the drive is not operating.
c) To prevent condensation, avoid sudden changes in temperature.
5 - 2
C141-E078-02EN
Advertisement
Table of Contents
