Drilling In Wood; Maintenance; Accessories; Repairs - DeWalt DCF060 Instruction Manual

• DO NOT CLICK THE TRIGGER OF A STALLED DRILL OFF AND
ON IN AN ATTEMPT TO START IT. DAMAGE TO THE DRILL CAN
RESULT.
• Minimize stalling on breakthrough by reducing pressure and
slowly drilling through last part of hole.
• Keep the motor running while pulling the bit out of a drilled hole
This will help reduce jamming.
• Make sure switch turns drill on and off.

Drilling In Wood

Holes in wood can be made with the same twist drill bits used for
metal. These bits should be sharp and should be pulled out frequently
when drilling to clear chips from the flutes.
NOTE: This tool is not recommended for drilling in metal or masonry.

MAINTENANCE

Your D WALT power tool has been designed to operate over a
E
long period of time with a minimum of maintenance. Continuous
satisfactory operation depends upon proper tool care and regular
cleaning.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Never use solvents or other harsh chemicals for
cleaning the non-metallic parts of the tool. These chemicals may
weaken the materials used in these parts. Use a cloth dampened only
with water and mild soap. Never let any liquid get inside the tool;
never immerse any part of the tool into a liquid.

Accessories

WARNING: Since accessories, other than those offered by
D WALT, have not been tested with this product, use of such
E
accessories with this tool could be hazardous. To reduce the risk of
injury, only D WALT, recommended accessories should be used with
E
this product.
Recommended accessories for use with your tool are available at extra
cost from your local dealer or authorized service center.
The following accessories should be used only in the sizes specified
below:
BITS - WOOD DRILLING – Up to 1/4" (7 mm).

Repairs

The tool and charger are not serviceable.
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustment (including brush inspection and replacement) should
be performed by authorized service centers or other qualified service
personnel, always using identical replacement parts.

Protecting the Environment

Separate collection. This product must not be disposed of
with normal household waste.
Should you find one day that your D
replacement, or if it is of no further use to you, do not dispose of it
with household waste.
Separate collection of used products and packaging allows
materials to be recycled and used again. Re-use of recycled
materials helps prevent environmental pollution and reduces
the demand for raw materials.
Local regulations may provide for separate collection of electrical
products from the household, at municipal waste sites or by the
retailer when you purchase a new product.
28
WALT product needs
E