How to use the active input. In active mode the internal passive low pass filter is bypassed, so you will have to power the Mycro Sub via an external active crossover. Set the active crossovers hi pass filter to 35 Hz and its low pass filter to 150 Hz.
Mycro TECHNICAL SPECIFICATIONS Mycro SUB Frequency Response : 41 Hz - 150 Hz -3dB Sensitivity : 95 dB 1w/1m Impedance : 2 x 8 ohms Power Handling : 2 x 200 watts rms Maximum Output : 119 dB cont 123 dB peak...
Failure to do so could delay the repair of your product. Warranty Registration Please take time to fill out the warranty registration form at the back of this manual and return it to Void Acoustics. Environmental WEEE Mark If you want to dispose of this product, do not mix with general household waste.
Authorised Void Dealer) that it is free of defects in materials and workmanship and that each product will meet or exceed all factory published specifications for each respective model. Void agrees to repair or replace (at its discretion) all defective parts at no charge for labour or materials; subject to following provisions:...
Page 8
Void Acoustics Unit 10B Dawkins Road Ind Est Poole Dorset BH15 4JD...
Need help?
Do you have a question about the MYCRO SUB and is the answer not in the manual?
Questions and answers