Stanley N128677 Instruction Manual page 14

How to Stop
Set the Off/Auto switch to "OFF".
Before First Start-up
Do not operate this unit until you read this instruction manual for safety,
operation and maintenance instructions.
Before Each Start-Up
1. Place Off/Auto switch to "OFF" and close air regulator.
2. Plug the power cord into the correct branch circuit receptacle. (Refer
to Voltage and Circuit Protection paragraph in the Installation section of this
manual.)
3. Turn the regulator knob counterclockwise until it stops.
4. Attach hose and accessories.
Risk of unsafe operation. Do not use damaged or worn accessories.
Risk of Bursting. Too much air pressure causes a hazardous risk of
bursting. Check the manufacturer's maximum pressure rating for air tools and accessories.
The regulator outlet pressure must never exceed the maximum pressure rating.
Risk of property damage. Compressed air from the unit may contain wa ter
condensation and oil mist. Do not spray un fil tered air at an item that could be damaged by
moisture. Some air tools and accessories may require filtered air. Read the in struc tions for
the air tools and accessories.
How to Start
1. Turn the Off/Auto switch to "AUTO" and allow tank pressure to build.
Motor will stop when tank pressure reaches "cut-out" pressure.
2. Turn the regulator knob clockwise until desired pressure is reached. The
compressor is ready for use.
14 - ENG