Ser Vice Journal; Pre-Deliv Ery Service; After The First 8 Hours - Husqvarna PR 17 Operator's Manual

Pre-deliver y service
1 Top up battery with acid and charge for four hours.
2 Fit the venting hose on the battery.
3 Fit steering wheel, seat and any optional equipment.
4 Adjust cutting unit:
Adjust lift springs (effective weight of cutting unit should be 12-15kg / 26.5-33 lb).
Adjust cutting unit so that rear edge is about 2-4 mm / 1/8" higher than front edge.
Adjust cutting unit height setting so that cutting height limit is 5 mm / 3/16" above the frame of the unit at the lowest
cutting height.
5 Check that the right amount of oil is in the engine.
6 Check that there is oil in the transmission's oil tank.
7 Check and adjust tyre pressure (60 Kpa, 0.6 bar).
8 Connect battery.
9 Fill with fuel and start engine.
10 Check that machine does not move in neutral.
11 Check:
Forward drive.
Reverse drive.
Operation of blades.
Seat safety switch.
Lif lever safety switch.
The safety switch for the hydrostat pedals.
12 Bleed the hydraulic system of excess air, top up with oil if necessary.
13 Check engine speed, 2900 ± 100 rpm.
14 Tell customer about:
Needs and benefits of following the service schedule.
Servicing and the influence of this journal on the second-hand value of the machine.
Range of applications for BioClip.
Complete proof of sale etc.
Pre-delivery service carried out. No outstanding problems. Certified:
Date, mileage, stamp, signature
After the fi rst 8 hours
1 Change engine oil

Ser vice journal

– 3
English