Black & Decker 1VPX Instruction Manual page 6

Inflator
Hide thumbs Also See for 1VPX:
Table of Contents

Advertisement

Available languages

Available languages

90521013 VPX Inflator manual
• Do not use an extension cord unless it is absolutely necessary. Use of improper
extension cord could result in risk of fire, electric shock, or electrocution.
• An extension cord must have adequate wire size (AWG or American Wire Gauge)
for safety. The smaller the gauge number of the wire, the greater the capacity of the
cable, that is 16 gauge has more capacity than 18 gauge. When using more than one
extension to make up the total length, be sure each individual extension contains at
least the minimum wire size.
• Do not operate charger with damaged cords or plugs — have them replaced
immediately.
• Do not operate charger if it has received a sharp blow, been dropped, or
otherwise damaged in any way.
• Do not disassemble charger. Incorrect reassembly may result in a risk of electric
shock, electrocution or fire.
• Disconnect the charger from the outlet before attempting any cleaning. This will
reduce the risk of electric shock. Removing the battery pack will not reduce this risk.
• The charger is designed to operate on standard household electrical power
(120 Volts). Do not attempt to use it on any other voltage.
• See instruction manual for use in countries other than the U.S.A.
• This power unit is intended to be correctly orientated in a vertical or floor
mount position.
INTRODUCTION
TM
VPX
chargers are designed to charge Black & Decker VPX
approximately 5-6 hours. The charger requires no adjustment and is designed to be as
easy as possible to operate. Simply place your battery pack into the receptacle of a
plugged in charger and it will automatically charge the pack. As you add new chargers to
TM
your VPX
system, utilize the "daisy chain" feature to power multiple chargers from a
single outlet.
IMPORTANT SAFETY INSTRUCTION FOR BATTERY PACKS
WARNING: For safe operation, read this manual and manuals originally supplied with
tool before using the charger.
The battery pack is not fully charged out of the carton. Before using the battery pack and
charger, read the safety instructions below. Then follow charging procedures outlined.
• Do not incinerate the battery pack even if it is severely damaged or is
completely worn out. The battery pack can explode in a fire. Toxic fumes and
materials are created when lithium ion battery packs are burned.
• Do not charge or use battery in explosive atmospheres, such as in the presence
of flammable liquids, gases or dust. Inserting or removing the battery from the
charger may ignite the dust or fumes.
• If battery contents come into contact with the skin, immediately wash area with
mild soap and water. If battery liquid gets into the eye, rinse water over the open eye
for 15 minutes or until irritation ceases. If medical attention is needed, the battery
electrolyte is composed of a mixture of liquid organic carbonates and lithium salts.
• Contents of opened battery cells may cause respiratory irritation. Provide fresh
air. If symptoms persists, seek medical attention.
WARNING: Burn hazard. Battery liquid may be flammable if exposed to spark or
flame.
• Charge the battery packs only in VPX
• DO NOT splash or immerse in water or other liquids. This may cause premature
cell failure.
• Do not store or use the tool and battery pack in locations where the temperature
may reach or exceed 105°F (40˚C) (such as outside sheds or metal buildings in
summer).
WARNING: Never attempt to open the battery pack for any reason. If battery pack case
is cracked or damaged, do not insert into charger. Do not crush, drop or damage battery
7/31/07
10:47 AM
SAVE THESE INSTRUCTIONS
READ ALL INSTRUCTIONS
TM
chargers.
6
Page 6
TM
battery packs in

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vpx1501

Table of Contents