opto engineering LTCLHP series Instruction Manual page 8

LTCLHP | instruction manual
2.3.2 Assembling instructions
Follow these steps to properly assemble the LTSCHP module.
1
Apply a small amount of thermal
grease on top of the LED support;
if you are using internal spacers
apply grease on both sides of the
spacers. *
5
Lock LED1W in place with two
provided screws. **
9
Connect the rear part to the LED
support using the provided M2X16
screws.
* Thermal grease not provided: make sure to use an appropriate thermal grease to improve the transfer of thermal energy across the
metal-to-metal interface (we suggest to use grease with thermal conductivity greater than 0.765W/mK).
**
Use the screws with the appropriate length according to the presence of internal spacers.
v 1.1
2
Position LED1W such that the black
and red cables can be inserted in
the lateral slot.
6
Pull out LED centering tool.
10
Insert external spacers, if needed.
3
Insert LED centering tool,
one dowel pin at a time.
7
LED1W is now correctly positioned
on the LED support.
11
Screw LTSCHP module on your
LTCLHP.
4
Now the LED1W is correctly
centered and positioned.
8
Insert connector.
12
Connect the power cable.
8