Table of Contents
Advertisement
2. Insert each screen rod through all rings
located at top of screen.
3. Insert first rod into rear hole in left side of
firebox. Fasten rod to rear hole near center
of firebox using #10 x 3/8" Phillips screw
provided (see Figure 13).
4. Insert other rod into front hole on right
side of firebox and fasten using remaining
Phillips screw.
Note: Use only original replacement parts.
This will protect your warranty coverage for
parts replaced under warranty.
PARTS UNDER WARRANTY
Contact authorized dealers of this product. If
they can't supply original replacement part(s),
call DESA Heating, LLC at 1-866-672-6040.
When calling DESA Heating, LLC, have
ready:
• your name
• your address
• model and serial numbers of your heater
• how heater was malfunctioning
• purchase date
You may have further questions about installa-
tion, operation, or troubleshooting. If so, con-
tact DESA Heating, LLC at 1-866-672-6040.
When calling please have your model and
serial numbers of your heater ready.
14
INSTALLATION
Continued
REPLACEMENT PARTS
TECHNICAL SERVICE
www.desatech.com
Top View of Rod Layout
Rear Hole
Front Hole
Rod
Ring
Screen
Figure 13 - Installing Fireplace Screen
(Model May Vary From Illustration)
Usually, we will ask you to return the part to
the factory.
PARTS NOT UNDER WARRANTY
Contact authorized dealers of this product. If
they can't supply original replacement part(s),
call DESA Heating, LLC at 1-866-672-6040 for
referral information. A list of authorized dealers
can be found by visiting www.desatech.com.
When calling DESA Heating, LLC, have
ready:
• model and serial numbers of your heater
• the replacement part number
Note: Firebox identification label (including
model number, serial number, clearances, etc.)
is located on right front edge of firebox.
You can also visit DESA Heating, LLC's web
site at www.desatech.com.
Identification
Label
Location
Screw
116208-01G
Advertisement
Table of Contents
