Table of Contents
Advertisement
Table of Contents
Inspection ................................................................................2
Model Nomenclature ...............................................................3
Wall Opening Requirements ....................................................4
Wall Box Installation ................................................................5
Outdoor Louver Installation .....................................................6
Heat Section Installation (Sizes 007-012) .........................6-7
Heat Section Installation (Size 019) .....................................8
Cooling Chassis Installation ................................................9
Units with Electric Heat (Sizes 007-012 ....................10-11
Units with Hydronic Heat (Sizes 007-012).................12-13
Units with Hydronic Heat (Size 019)...............................13
Room Cabinet and Control Installation .............................14-15
Equipment Start-up .............................................................15
Ventilation .......................................................................16
Remote Mounted Thermostat Installation ..............................16
Typical Wiring Diagrams ................................................17-25
(Sizes 007-012) .............................................................17
(Size 019) .......................................................................18
Installation
The installation of this equipment shall be in accordance with the
regulations of authorities having jurisdiction and all applicable
codes. It is the responsibility of the installer to determine and
follow the applicable codes. Sheet metal parts, self-tapping
screws, clips and such items inherently have sharp edges, and it
is necessary that the installer exercise caution. This equipment
is to be installed only by an experienced installation company
which employs trained personnel.
Inspection
When the equipment is received, all items should be carefully
checked against the bill of lading to be sure all crates and cartons
have been received. All units should be carefully inspected
for damage when received. If any damage is noticed, the
carrier should make the proper notation on the delivery receipt
acknowledging the damage.
Figure 1: Type K Unit Components
IM 1068 / Page 2 of 32
(Sizes 007-012) .............................................................19
(Size 019) .......................................................................20
(Sizes 007-012) .............................................................21
(Size 019) .......................................................................22
(Sizes 007-012) .............................................................23
(Sizes 007-012) .............................................................24
(Sizes 007-012) .............................................................25
Scheduled Maintenance ........................................................26
Recommended Spare Parts ..................................................27
Troubleshooting Chart ..................................................... 28-29
Approximate Shipping Weights ............................................ 30
The carrier should also fill out a Carrier Inspection Report.
The McQuay International Traffic Department should then be
contacted.
The unit nameplate should be checked to make sure the voltage
agrees with the power supply available.
The Type K Series Comfort Conditioner is designed and built
for through-the-wall installation in either new or existing
buildings. The self-contained refrigerant system delivers cooling
to the desired space. Heating can be accomplished with electric
resistance or hydronic heat. Each conditioner consists of the
following components:
● Cooling Chassis
● Heat Section
● Control
● Room Cabinet
● Wall Box
● Louver
Hide quick links:
Advertisement
Table of Contents
