The Screen - Panasonic PT-D5600E Operating Instructions Manual

Replacing the lamp unit
PICTURE
POSITION
ADVANCED MENU
LANGUAGE
OPTION1
OPTI0N2
TEST PATTERN
SYSTEM INFORMATION
ROM VERSION
SET RUNTIME
LAMP1 LOW
HIGH
TOTAL
LAMP2 LOW
LAMP TIME RESET
LAMP1
LAD55
LAD55L
LAMP2
LAD55
LAD55L
44
Downloaded From projector-manual.com Panasonic Manuals
Insert the power cord plug into the wall outlet and then
press the MAIN POWER switch.
Attention
Press the " I " button so that a picture is projected onto

the screen.

MENU
Press the "MENU" button to display the MAIN MENU
screen, and then press the
the cursor to select "OPTION2".
Press the "ENTER" button to display the "OPTION2"
screen, and select "SYSTEM INFORMATION" with the
and
1. 00. 00
300h Press the "ENTER" button.
100h
The SYSTEM INFORMATION screen will be displayed.
200h
300h
100h
Press and hold the "ENTER" button on the projector or
the remote control for approximately 3 seconds.
An item "LAMP TIME RESET" will be added.
1433h
Select the lamp which has been replaced with the
0h
1100h
LAMP1: Replace the LAMP UNIT 1
0h
LAMP2: Replace the LAMP UNIT 2
Press the ENTER button, and when the "LAMP TIME
RESET" display flashes, press the ENTER button again.
The used hours of the specified lamp unit will be reset to zero.
When more than one lamp has been replaced, repeat the procedure from
step
• If the power does not turn on even after turning the MAIN
POWER switch "I", turn the MAIN POWER "O", confirm that
the lamp unit and door are installed correctly, and turn on
again.
buttons.
buttons.
.
• When the "LAMP TIME RESET" display flashes, the lamp
Note
time reset can be canceled by pressing the MENU button.
• The used hours of the lamp units can also be reset to zero
by taking the following action instead of steps
When lamp unit 1 has been replaced:
In the standby mode, press the number buttons in the
sequence of 737381, and then press the ENTER button.
When lamp unit 2 has been replaced:
In the standby mode, press the number buttons in the
sequence of 737382, and then press the ENTER button.
When the used hours have been reset, the lamp monitor
(LAMP1/LAMP2) will flash for 3 seconds.
and buttons to move
to
and
.