Care And Maintenance; Air Filter Removal/Cleaning/Mounting; Unit Idle For A Long Time - Midea PORTABLE AIR CONDITIONER Owner's Manual

Air filter
(take out)
Fig.26
Remove the
screws and
take the air
filter down
Model A
Fig.27
Remove the
screws and
take the air
filter down
Model B
Fig.28

CARE AND MAINTENANCE

CARE AND MAINTENANCE
IMPORTANT:
1) Be sure to unplug the unit before cleaning or servicing.
2) Do not use gasoline, thinner or other chemicals to clean
the unit.
3) Do not wash the unit directly under a tap or using a hose.
It may cause electrical danger.
4) If the power cord is damaged, it should be repaired by
manufacture or its agency.
1. Air filter
- Clean the air filter at least once every two weeks to prevent
inferior fan operation because of dust.
- Removal
This unit has two filter. Take the upper filter out along the
the arrow direction(Fig.26),then takel the filter down.
Remove the lower filter by loosening the screw, taking down
the air filter as shown in Fig.27 and Fig.28.
- Cleaning
Wash the air filter by immersing it gently in warm water
O O
(about 40 C/104 F) with a neutral detergent. Rinse the filter
and dry it in a shady place.
- Mounting
Install the upper air filter after cleaning and install the lower
filter by using the screw.
NOTE: The grill and the air filer are connected and can not be
separated..
2. Unit enclosure
- Use a lint-free cloth soaked with neutral detergent to clean
the unit enclosure. Finished by a dry clean cloth.

3. Unit idle for a long time

- Remove the rubber plug at the back of the unit and attach
a hose to drain outlet
directly over the drain area in your basement floor
(See Fig.23 & 24).
- Remove the plug from the bottom drain outlet, all the water
in the bottom tray would drain out (See Fig.25).
- Keep the appliance running on FAN mode for half a day in
a warm room to dry the appliance inside and prevent mold
forming.
- Stop the appliance and unplug it, wrapped the cord and
bundle it with the tape. Remove the batteries from the
remote controller.
- Clean the air filter and reinstall it.
- Disconnect the exhaust hose, keep it safety, and cover the
window(wall) hole with the adaptor cap.
. Place the open end of the hose
14