Midea PORTABLE AIR CONDITIONER Owner's Manual page 10

FOLLOW ME operation(on some models)
This feature can be activated from the
remote control ONLY. The remote
control serves as a remote thermostat
allowing for the precise temperature
control at its location.
To activate the Follow Me feature, point
the remote control towards the unit and
press the Follow Me button. The light on
the unit control panel will illuminate to
indicate it received the signal.It will
continue to send this signal until the
feature is deactivated by pressing the
Follow Me button again. If the unit does
not receive the Follow Me signal during
any 7 minutes interval, the unit will beep
to indicate the Follow Me mode has en
ded. The display on the remote control
indicates the temperature at the remote
ONLY.The actual temperature can be
displayed at the unit by pressing the Fan
Only mode. When in the Cool mode, the
unit display indicates the set temperature.
Auto sliding panel slide down automatically
Danger !Do not put
fingers here.
Auto sliding panel slide up automatically
Swing automatically
Fig.6
ION operation(on some models)
This feature can be activated from the
remote control ONLY.
To activate the ION operation ,the anion
generator is energized and will help to
remove pollen and impurities from the air.
SLEEP operation
Press this button, the set temperature will increase
(cooling) or decrease(heating) by 1
minutes.The set temperature will then increase
(cooling) or decrease (heating) by another 1
after an additional 30 minutes. This new temper-
ature will be maintained for 7 hours before it returns
to the originally selected temperature. This ends
rate as originally programmed.
NOTE:
DRY mode.
LOCK operation
Press and hold the SWING and MODE buttons
simultanuously for 3 seconds will lock the panel.
It will not slide even the machine is turned off.
NOTE: This machine is specially designed with an
auto sliding panel. When the unit turns on, it will slide
down automatically.And the air outlet is open(See Fig.5a)
.When the unit turns off, the panel slides up automatically
and this may cause about 50-80N strengh(See Fig.5b) .
Please pay attention do not put the fingers on the
air outlet when the unit turns off and ensure children
do not operate or play with the machine.
Fig.5a
Other features
Power Outage
In the case of a power outage or interruption,
the unit will auto matically re-start, in the
settings as used, after the power is restored.
Wait 3 minutes before resuming operation
After the unit has stopped, it can not be restarted
operation in the first 3 minutes. This is to protect
the unit. Operation will automatically start after
3 minutes.
Air flow direction adjustment
Fig.5b
The louver can be adjusted automatically .
-
OPERATING INSTRUCTIONS
the Sleep mode and the unit will continue to ope-
This feature is unavailabe under FAN or
WARNING
Adjust the air flow direction automatically
(Fig.6):
When the Power is ON, the louver opens fully.
Press the SWING button on the panel or
remote controller to initiate the Auto swing
feature.
The louver willl swing up and down
automatically.
Please do not adjust the louver manually.
O O
C/2 F in 30
O O
C/2 F
8