Troubleshooting - Panasonic TH-103PF9EK Operating Instructions Manual

7. Troubleshooting

In this chapter you find information concerning the topics: Possible problems and their solution as well as
control display error messages.
Control or remote control does not function
Voltage supply cable is not connected
Remote Control is not connected
Bad plug contact
Control defective
Remote Control defective
Power cable defective
Lift runs in one direction only
Lift is defective
Control is defective
Control panel is defective
Control defective
ScreenLifter does not exceed lift position 39
Switch on bottom of cap was pressed accidentally
Surface too soft (e.g. shag pile carpet)
Control panel is defective
Display shows message "HOT"
The control has a built-in overheat protection. The protection is active
due to overheat.
ScreenLifter moves only gradually
Protective switch active due to mechanical resistance
Possible cause
Possible cause
Possible cause
Possible cause
Possible cause
Connect the voltage supply cable of the control
Connect the control
Connect the control and the supply cable correctly
Contact the dealer
Replace remote control
Contact the dealer
Contact the dealer
Contact the dealer
Connect the control and the supply cable correctly
Contact the dealer or replace remote control
Insert transportation pins, Lift cap up and check
whether switch on bottom of cap was pressed by any
object (see Chap. 4.2).
Move ScreenLifter or change surface (see Chap. 4.2)
Connect the control and the supply cable correctly
Wait until the control has cooled down and the display
message "HOT" has ceased. (at least 15min.) After that
period the control can be used again.
Contact the dealer.
21
Solution
Solution
Solution
Solution
Solution