•
If the ScreenLifter is still in the transportation case, proceed as specified in chapter 4.2.1, to lift
it from its roll case. Make sure that the Screen-Lifter is placed on an even and firm surface.
•
Caution! The frame is smaller than the display. Make sure there is enough room, particularly
next to and below the frame.
•
Insert the display from top to bottom to the frame plate, so that the groove of the display
adapter slides into the plate.
•
To simplify the positioning, the two lower plates are a bit longer. Insert the lower plates first.
•
When correctly assembled, the display sits firmly on the frame and the drill hole of the middle
plate covers the tapped hole of the display.
•
Secure the display now by inserting the two screws M 16 x 50 through the drill holes of the
middle plate into the display.
•
Check the power connection of the display. If the power specifications are identical to those
of the ScreenLifter, you can connect the display to the ScreenLifter power socket.
•
Max. capacity of helix cable for power supply of the display: 2000 W. Please note the power
supply requirements of the display!
16