Table of Contents
Advertisement
Setting the Central-Control Address
CANCEL
SET
ON
OFF
AUTO CLEAN
NOTICE
❏ You are recommended to follow below procedure to check indoor-unit address with
remote-controller.
Press RESET button once with the wind direction button(
The LCD DISPLAY on remote-controller shows '88'. When you press START/STOP button
on your remote-controller directed toward the receiver of indoor-unit at this time, the display
LED of indoor-unit lights at the initial set address.
When RESET button is pressed once with JET COOL button
1
held, '00' will be shown on the LCD DISPLAY and it'll enter
into the address set mode.
Whenever you press the Temperature Increase(UP) button,
2
the group address number also increases.(Left-digit)
And whenever you press the Temperature Decrease(DOWN)
button, the indoor-unit address number also increases.
(Right-digit) (Control scope of Group Address No. and
Indoor-unit Address No. : 00~FF)
To raise the temperature
To lower the temperature
When you press the START/STOP button on your
3
remote-controller directed toward the receiver of indoor-unit
after setting address, the address would be set.
When you press RESET button after completing address
4
setup, the address setup function will be cancelled.
In the state of cancellation, LCD display shows the initial
standby mode.
Owner's & Installation Manual 19
Setting the Central-Control Address
(00, ...., 90, A0, ...., F0)
(00, ...., 09, 0A, ...., 0F)
(Address No.3 indoor-unit
of Second Group)
) of remote-controller held.
Advertisement
Table of Contents
