Club Weider 550weight bench User Manual page 13

24. Press four 25mm x 50mm Inner Caps (79) into the
ends of the Backrest Frame (78). Attach the
Backrest Bracket (89) to the Backrest Frame using
two M10 x 25mm Bolts (43) and two M10 Nylon
Locknuts (11).
25. Attach the Backrest (69) to the Backrest Frame (78)
with four M6 x 65mm Screws (62) and four M6
Washers (81). Make sure that the Backrest is
turned as shown.
26. Lubricate an M10 x 180mm Bolt (76). Attach the
Backrest Frame (78) to the Bench Frame (63) using
the Bolt, two M10 Small Washers (6), and an M10
Nylon Locknut (11). Slide the Backrest Bracket (89)
into the indicated slot on the Bench Frame. Do not
overtighten the Nylon Locknut; the Backrest
must be able to pivot freely.
To adjust the position of the Backrest, pull the
Backrest Knob (80) outward and move the Backrest
up or down. Slowly release the Backrest Knob,
making sure that the pin on the Backrest Knob is
inserted through one of the holes in the Backrest
Bracket (89).
27. Attach the Seat (68) to the Bench Frame (63) with
four M6 x 16mm Screws (61). Make sure that the
Seat is turned as shown.
24
11
79
25
69
Wide
End
26
76
6
27
68
Wide
End
13
79
78
89
43
81
78
62
81
62
69
78
89
80
63
6
11
63
61