Club Weider 550weight bench User Manual page 10

13. Press a 50mm Square Inner Cap (10) into each end
of the Pulley Bar (59). Slide the bracket on the
Pulley Bar into the top of the Rear Upright (2).
Attach the Pulley Bar to the Rear Upright using two
M10 x 65mm Bolts (56), four M10 Small Washers
(6), and two M10 Nylon Locknuts (11).
Attach the Pulley Bar (59) to the Top Crossbar (9)
using a Support Plate (57), two M10 x 80mm Bolts
(41), and two M10 Nylon Locknuts (11).
Tighten all Nylon Locknuts used in steps 1
through 13.
15. Route the High Cable (13) around another Pulley
(5) and through the indicated slot in the Pulley Bar
(59) as shown. Attach the Pulley inside the slot
using an M10 x 65mm Bolt (56), two M10 Large
Washers (58), two Pulley Spacers (15), and an M10
Nylon Locknut (11). Do not overtighten the Nylon
Locknut; the Pulley must be able to turn freely.
16. Route the High Cable (13) up through the Pulley
Bar (59) and around another Pulley (5) as shown.
Attach the Pulley inside the slot in the Pulley Bar
using an M10 x 65mm Bolt (56), two M10 Large
Washers (58), two Pulley Spacers (15), and an M10
Nylon Locknut (11). Do not overtighten the Nylon
Locknut; the Pulley must be able to turn freely.
14
15 5
15
11 58
13
58
Ball
56
59