Installing The Software; Using The Software - Kolor PANOGEAR PACK User Manual

2. Installing the software


Once the CD has been inserted into your computer, open the explorer file and click on the folder named "Panorama_Eng".
Double-click on the Setup.exe file to begin the software installation.

Attention: You must have the Microsoft .Net 2.0 extension or higher to be able to install the software. If you receive an error
message, download and install the extension for free from the Microsoft website: http://www.microsoft.com/downloads/fr-
fr/results.aspx?freetext=.Net+2.0&displaylang=fr&stype=s_basic

3. Using the software


Verify that your controller is connected to the computer with the
USB cord (USB will be displayed on the controller's screen) then
launch the Panorama software.
appear asking you to select the connected controller. If you only
have one connected device, you can simply click on continue (if
nothing happens, wait while the computer detects the device and
then reopens the software).

File Menu :
1. Save: Save the configuration on the hard drive.
2. Open: Open the saved configuration on the hard drive.

Name: Name your profile (model/camera type: Nikon, Canon etc.)

Focal Length: Define your focal length.

Horizontal sensor: Define the camera's sensor width. For a full-frame, it's 36mm. APS-C or DX lens formats will be a smaller
size. Reference your camera's instruction manual for the size.

Vertical sensor: Define the camera sensor height. For example, 24mm for a full-frame.

Nodal: Locate the nodal point (the value is determined by each model and varies according to the lens model). The distance
will be given on the controller screen as a guide for setting up the camera.

Select Portrait or Landscape: Select the camera orientation: portrait or landscape.

Select Standard or Fisheye Lens : Select the lens type: Standard or Fisheye ( Fisheye, a field will appear allowing you to
choose a diagonal view angle : 0° <-> 360°)

Wire, IR Canon etc. : Connection mode. Always select « Wire ».

Add : Add your created profile to the profile list

Insert: Insert the profile to the indicated (highlighted) spot in the list.

Read: Open the selected profile (highlighted).

Remove: Delete the selected profile (highlighted).
Panogear Pack | User Manual
At the startup a window will
7