Set Up The Speaker Parameters Automatically (Ypao) - Yamaha HTR-5063 Owner's Manual

Set up the speaker parameters automatically (YPAO)

This unit is equipped with a YPAO (Yamaha Parametric Room Acoustic Optimizer) that adjusts the status, size, and volume balance of the speakers in order to provide an optimal sound field. Using
YPAO allows you to automatically configure settings for which specialist knowledge is usually needed, such as adjusting speaker output and acoustic parameters to suit your listening room (the room
J1
in which this unit is placed).
When you use YPAO, a test tone will be output from the
speakers for approximately 3 minutes and acoustic measuring
will be performed. When using YPAO, be careful of the
following.
• The test tone is output at high volume. Please refrain from using
this function at night when it may be a nuisance to others nearby.
• Please take care that the test tone does not frighten any small
children.
You can view the operations of YPAO on the front panel display
or on the OSD (On-Screen Display) displayed on your TV while
you use it. This explanation uses references to the OSD display
on your TV.
Check the following before using YPAO.
1
This unit
• The headphones are removed.
TV
• This unit is connected to the TV correctly.
• The power is turned on.
• The video input to which the video output from this unit has been
selected.
Subwoofer
• The power is turned on.
J
1 : When you have changed the number of speakers or the locations in which they
are installed, first use YPAO to adjust the speaker balance.
J
2 :
To cancel measurement, disconnect the YPAO microphone.
• Volume is set to approximately half, and the cross-over frequency (if
present) is set to maximum.
CROSSOVER/
VOLUME HIGH CUT
MIN MAX MIN
Subwoofer examples
Place the supplied YPAO microphone at ear height in
2
your listening position.
Face the head of the YPAO microphone upwards.
YPAO microphone
When positioning the microphone, we recommend that you use
equipment that allows you to adjust the height (such as a tripod)
as a microphone stand. When using a tripod, use the tripod
screws to fix the microphone in place.
3 Switch this unit on.
Connect the YPAO microphone to the YPAO MIC jack
4
on the front panel.
MAX
"MIC ON. View OSD MENU" appears on the front panel display,
and the following appears on the TV screen.
CONNECTIONS
YPAO MIC
INFO
J2
Auto Setup
EQ Type;;;;Natural
. Start
[OPTION]:EQ Select
[SETUP]:Start
Continues to the
next page
24
En