Adding Items During A Cycle; Option Selections - KitchenAid KUDS01IJ Use And Care Manual

Adding Items During a Cycle

You can add an item anytime before the main wash starts. Open
the door and check the detergent dispenser. If the cover is still
closed, you can add items.
To add items
1. Lift up the door latch to stop the cycle. Wait for the spraying
action to stop before opening the door.
2. Open the door. If the detergent dispenser cover is still closed,
add the item.
3. Close the door firmly until it latches. The dishwasher resumes
the cycle after about a 5 second pause.

Option Selections

You can customize your cycles by pressing an option. If you
change your mind, press the option again to turn the option off.
Select a different option if desired.
You can change an option anytime before the selected option
begins. For example, you can press an unheated drying option
any time before drying begins.
Press Start to repeat the same cycle and options as the previous
wash cycle.
NOTE: If the last cycle you completed was a rinse cycle, when
you press Start, the dishwasher runs the last full wash cycle and
options.
Hi-Temp Scrub
Select this option to heat the water during parts of the cycle, and
add a rinse. Higher water temperatures and an extra rinse helps
clean tough soils. Hi-Temp Scrub, with the Baked On Cookware
cycle, raises the water temperature in the prewash and main
wash. Hi-Temp Scrub, with the Normal cycle, raises the water
temperature in the main wash.
This option adds heat, water and wash time to a cycle.
NOTE: Hi-Temp Scrub is an option with the Baked On Cookware
and Normal cycles.
Sani Rinse
Select this option to raise the water temperature in the final rinse
to approximately 160°F (71°C) for 10 minutes. Sani Rinse adds
heat and time to the cycle. In the Normal cycle, this high-
temperature rinse sanitizes your dishes and glassware in
accordance with the NSF Protocol P153 Sanitization and
Cleaning Performance of Household Spray-Type Dishwashers.
NOTE: Baked On Cookware automatically uses this option. Sani
Rinse is an option with the Normal cycle.
Energy Saver Dry
Select this option to dry dishes without heat and save energy.
Energy Saver Dry is useful when loads contain plastic dinnerware
that may be sensitive to high temperatures.
14
The dishes take longer to dry and some spotting can occur. For
best drying, use a liquid rinse aid. Some items (such as plastics)
may need towel drying.
NOTE: Rinse Only automatically uses this option. Energy Saver
Dry is an option with all other cycles.
Control Lock
Use Control Lock to prevent unintended use of the dishwasher.
You can also use the control lock feature to prevent unintended
cycle or option changes during a cycle.
When Control Lock is lit, all buttons are disabled.
NOTES:
The dishwasher door can be opened while the controls are
locked.
You can turn on the Lock while the dishwasher is running.
To turn on the Lock
Press and hold
for 4 seconds. Control Lock glows.
If you press any pad while your dishwasher control is locked, the
light flashes 3 times.
To turn off the Lock
Press and hold Energy Saver Dry for 4 seconds. The light turns
off.
Delay Hours
Select this option to run your dishwasher at a later time or during
off-peak hours. You can add items to the load anytime during the
delay countdown. After adding items, close the door firmly until it
latches. The delay countdown will not continue if the door is not
latched.
You can delay the start of a cycle up to 24 hours.
The first time you select Delay Hours, you will see
showing a 1 hour delay.
To delay the start
1. Close the door.
2. Select a wash cycle and options.
3. Repeatedly press
until you see the desired hours of delay in the display.
When the delay reaches 24 hours, the delay turns off. Press
Delay Hours again to select a new number of delay hours.
NOTE: The delay is set at one-hour increments for the first 12
hours. The remaining delay hours are set at two-hour
increments.
4. Press Start.
NOTE: To cancel the delay, press Delay Hours until no delay
hours show in the display or press Start.