Advertisement
The low power consumption of the charger will NOT drain your
car's battery when leaving the flashlight stored in the charger and
connected through the DC plug.
To Charge:
Insert the tail end (with gold rings) of the UC3.400 flashlight into the charger
unit until it "snaps" into place. Once inserted, the flashlight will immediately
begin its 90 second charge cycle.
The status of the charge is indicated by the blue LED on the charger. The
LED will begin with a slow steady blink and increase its speed until it reaches
a steady illumination at the end of the cycle. This steady blue light indicates
the UC3.400 is fully charged and ready for use.
After the initial charge cycle, there may be brief periods of additional LED
activity. This is perfectly normal as it indicates the ongoing maintenance
of the energy stored in the capacitors. Our FlashPoint
constantly monitors the level of power available in the unit to ensure that
your flashlight is always fully charged and ready for peak performance.
Note: High Temperature Charging
Your flashlight charger has automatic temperature overload protection.
Charging in high temperatures (i.e, 120 degrees Fahrenheit or more) may
temporarily reduce the flashlight runtime slightly.
C. Mounting your Flashlight (Automotive Mounting)
1. Select suitable location for mounting, e.g. the transmission "hump".
2. Using the attached template, mark and drill 4 – ¼" holes.
3. Secure the back bracket to the mounting location using the screws
6
TAC59063_UC3400_UserGuide_510.indd 6
provided.
UC3.400 User Guide
Power Technology
®
5/10/10 4:38 PM
Advertisement
