Table of Contents
Advertisement
Step
1
Select the area to mount the Asterisk Appliance 50 unit
(refer to Figure 4 on page 26). The unit should be
mounted at or below eye level to properly view the
LEDs.
2
Install two #8 PAN headscrews (1 1/2-inch or longer)
into the desired location on the wall. They should be
placed approximately 7 1/2-inches, or 19cm, apart
horizontally or vertically, which is the distance between
the two keyed insets on the back of the AA50. Make sure
that the two screws are in alignment and level.
3
Leave approximately 1/4-inch of the screw protruding
from the wall to allow the head of the screws to slide into
the keyed insets, mounting the unit to the wall.
Warning
The AA50 should not be mounted with the LEDs pointing
downward. Mounting the AA50 with the LEDs pointing
downward may cause a disruption in air circulation, which
could cause the AA50 to overheat. Mounting the AA50 this way
can also expose the LAN, WAN, and analog ports to potential
damage.
Release 1.20
Table 2: Wall Mounting
Instructions for Wall Mounting
Digium, Inc.
Chapter 2: Unit Installation
Page 27
Advertisement
Table of Contents
