Digium Asterisk Appliance 50 AA50 Administrator's Manual page 25

Click Save, and then click Apply Changes. Your changes will be
7.
applied and Asterisk will reload.
Attach the ethernet cable connected to the AA50's LAN port to the
8.
WAN port. Connect the other end of the cable to the appropriate
internet connection (will vary depending on your setup). This will
connect the Asterisk Appliance 50 to the internet.
9. Connect telephones to the analog ports that are configured as FXS
ports and connect phone lines to the analog ports that are configured as
FXO ports.
Using an AA50 supported web browser, open a browser window and
10.
enter the IP address for the AA50. The default username is admin, and
the password is will be the password you chose after first logging into
the AA50.
You are now ready to configure your Asterisk Appliance 50 via the
11.
GUI.
Caution.
This unit must be connected to the Telecommunications
Network in your country using an approved line cord, e.g.: for
Australia use only line cords complying with ACA Technical
Standard TS008.
Release 1.20 Digium, Inc.
Chapter 2: Unit Installation
Page 25