WAGO TP343 Manual page 44

The material is then loaded. To do this, open the printer (cf. Page 8).
Remove the marker strip from within the printer and remove the spool from the unwinder.
Then pull the material sensor (1) and the green side section (2) apart and remove the
gray strip guide (3). Then pull the material sensor and the green side section apart by ca.
85 mm. The marker sensor (4) can be seen below.
Place the material spool on the 3"-core and place this on the external unwinder.
Feed the material through the opening in the back of the printer as shown in the illustrati-
on below.
44
Thermotransferdrucker TP 343