Chapter 2 Setting The Network Camera Over The Lan - HIKVISION DS-2CD2012-I Installation Manual

Chapter 2 Setting the Network Camera over
Purpose:
To view and configure the camera via LAN (Local Area Network), you need to connect the network
camera in the same subnet with your PC. Then install the iVMS-4200 software to search and change
the IP address of the network camera.
 The following figure shows the cable connection of a network camera and a PC:
 Set the IP address of the camera for accessing via LAN.
Steps:
1. Use iVMS-4200 client software to detect the online devices. Please refer to the user manual of
iVMS-4200 client software for detailed information.
● Search online devices automatically
After launch iVMS-4200 software, it automatically searches the online devices every 15
seconds from the subnet where your computer locates. It displays the total number and
information of the searched devices in the Online Devices interface.
Go to Device Management, and click Server tab on the left-top of the window, and you can
see the online devices listed on the right bottom of the window.
the LAN
Figure 2-1 Wiring over LAN
Figure 2-2 Search Online Devices
www.eyesoniccctv.com
9