Electrical Adjustments - Sony HCD-GTX777 Service Manual

HCD-GTX777/GTX787/GTX888
QQ
3 7 63 1515 0
0 dB = 1 µV
TUNER SECTION
[FM Tune Level Check]
SET
Procedure:
1. Turn the power on.
2. Input the following signal from Signal Generator to FM an-
tenna input directly.
* Carrier Freq : A = 87.5 MHz, B = 98 MHz, C = 108 MHz
Deviation : 75 kHz
Modulation : 1 kHz
ANT input : 35 dBu (EMF)
Note: Please use 75 ohm "coaxial cable" to connect SG and the set. You
cannot use video cable for checking.
Please use SG whose output impedance is 75 ohm.
3. Set to FM tuner function and tune A, B and C signals.
4. Confi rm "TUNED" is lit on the display for A, B and C sig-
nals.
TE
L 13942296513
The mark of "TUNED" means "The selected station signal is re-
ceived in good condition."
www
.
28
http://www.xiaoyu163.com
SECTION 5

ELECTRICAL ADJUSTMENTS

FM signal generator
OUT (75 7)
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
DECK SECTION
1. Demagnetize the record/playback head with a head
demagnetizer.
2. Do not use a magnetized screwdriver for the adjustments.
3. After the adjustments, apply suitable locking compound to the
parts adjust.
4. The adjustments should be performed with the rated power
supply voltage unless otherwise noted.
5. The adjustments should be performed in the order given in this
service manual. (As a general rule, playback circuit adjust-
ment should be completed before performing recording circuit
adjustment.)
6. The adjustments should be performed for both L-CH and R-
CH.
7. Switches and controls should be set as follows unless otherwise
specifi ed.
• Test Tape
Tape Signal
P-4-A100 10 kHz, –10 dB
[RECORD/PLAYBACK HEAD AZIMUTH
ADJUST-MENT]
Note: Perform this adjustments for Single deck
Q Q
3 6 7 1 3 1 5
Procedure:
1. Mode: Playback
(L-CH & R-CH)
test tape
P-4-A100
(10 kHz, –10 dB)
set
2. Turn the adjustment screw and check output peaks. If the peaks
do not match for L-CH and R-CH, turn the adjustment screw
so that outputs match within 1dB of peak.
within
L-CH
1dB
peak
output
level
R-CH
peak
screw
position
co
.
9 4 2 8
0 dB = 0.775 V
Used for
Azimuth Adjustment
0 5 8 2 9 9 4 2 8
level meter
+
–
within
1dB
screw
position
L-CH R-CH
peak peak
m
9 9
9 9