Setting Dynamic Range Control (Drc); Changing Station Display Order; Pruning Your Station List; Viewing Station Information - View Quest Hepburn Operation Manual

GB
3. To exit manual tune, press the - TUNING + knob again.

Setting Dynamic Range Control (DRC)

You can set the compression level of stations to eliminate the di erences in dynamic range or sound level between
radio stations. If loud stations are too loud while quiet stations are too quiet, DRC may help.
Note: DRC o indicates no compression
DRC low indicates little compression
DRC high indicates maximum compression
1. Press the MENU button, turn the – TUNING + knob to select DRC, and press the - TUNING + knob to con rm.
2. Turn the -TUNING+ knob to select 'DRC high' , 'DRC low' or 'DRC o ' , and then press the - TUNING + knob to
con rm your setting.

Changing Station Display Order

You may want to display your stations in a di erent order. Your options are:
Alphanumeric:
Ensemble:
Valid:
1. Press the MENU button, turn the - TUNING + knob to select Station order, and then press the - TUNING + knob to
con rm.
2. Turn the – TUNING + knob to select 'Alphanumeric' , 'Ensemble' or 'Valid' , and then press the – TUNING + knob to
con rm your selection.

Pruning Your Station List

This feature enables your radio to remove inactive stations from the station list.
1. Press the MENU button, turn the – TUNING + knob to select Prune, and then press the
– TUNING + knob to con rm.
2. Turn the – TUNING + knob to 'Yes' , and then press the – TUNING + knob to con rm.

Viewing Station Information

To view currently playing station information, press the INFO button repeatedly to cycle through DLS (Dynamic Label
Segment), Signal Strength, Program Type, Ensemble, Program Frequency, Signal Quality, Bitrate, Codec and Time
and Date.
13
Display all stations in alphanumeric order.
List currently broadcasting active stations before inactive ones.
Remove inactive stations from the station list.
Hepburn Operation Guide