W a r n i n g
4
Installation Summary
Installation Steps
To add redundant power to your Switch 2000, follow these steps:
1. Disconnect the power supply from the Switch 2000 before
installing the RPS. Electrical shock or other injury can result
if you attempt to install the module without unplugging the
Switch 2000.
2. Using a Torx T-10 or flat-bladed screw driver, loosen the five cap-
tured screws on the cover plate on the back of the Switch 2000.
Loosen these screws
3. Store the cover plate.
(Steps continued on next page.)