Initial Inspection; Outline Drawing; Installation - HP 59501A Operating And Service Manual

SECTION H
INSTALLATION
2-1 INITIAL INSPECTION 2-11 Outline Drawing
2-2 Before shipment, this instrument was inspected 2-12 Figure 2-1 illustrates the outline shape and
and found to be free of mechanical and electrical defects.
As soon as the instrument is received, proceed as instructed
in the following paragraphs.
2-3 Mechanical Check
2-4
ask the carrier's agent to be present when the instrument is
unpacked. Check the instrument for external damage such
as broken switches or connectors, and dents or scratches on
the panel surfaces. If the instrument is damaged, file a claim
with the carrier's agent and notify your local Hewlett-
Packard Sales and Service Office as soon as possible (see
list at rear of this manual for addresses).
2-5 Electrical Check
2-6 Check the electrical performance of the instrument
as soon as possible after receipt. Section V of this manual
contains procedures which will verify instrument operation
on the HP-iB. These procedures are also suitable for incom-
ing quality control inspection. Refer to the inside front
cover of the manual for the Certification and Warranty
statements. š
2-7 REPACKAGING FOR SHIPMENT
2-8 To insure safe shipment of the instrument, it is
recommended that the package designed for the instrument
be used. The original packaging material is reusable. Hf it
is not available, contact your local Hewlett-Packard field
office to obtain the materials. This office will also furnish
the address of the nearest service office to which the instru-
ment can be shipped. Be sure to attach a tag to the instru-
ment specifying the owner, model number, full serial
number, and service required, or a brief description of the
trouble.
2-9 INSTALLATION DATA
2-10 The 59501A is shipped ready for operation on the
HP-IB. Before connecting it to a controller and applying
power, read paragraph 2-26.
If external damage to the shipping carton is evident,
2-1
dimensions of Model 59501 A.
213 Rack Mounting
2-14 The 595017 A can be rack mounted in a standard
19-inch rack panei either by itself or alongside another
half (or quarter) System-ll module of equal height and
depth. All rack mounting accessories for this unit are
listed in paragraph 1-11, Also, complete installation
instructions are included with each rack mounting kit.
2-15 Eguipment Reguired
2-16 If an HP calculator is used to program the 59501A,
the following equipment is required:
HP RR %
Calculator I/O Card Package
59405A Option 0207
HP-1B I/O
59405A Option 021*
HP-IB O
98034A HP-IB i/O General 1/O
Extended I/O
59405A Option 030* *
HP-IB [/O
a includes Peripheral Control H ROM
** includes Extended I/O ROM
if an HP-2100 series computer is used as the
controller, the 59310B HP-IB Computer Interface
card is reguired.
` + <
2-17 HP-IB Connector
2-19 The HP-IB connector on the rear of the 59501A
interfaces directly to the HP-IB, Figure 2-2 illustrates the
pin configuration of the HP-1B connector which is a 24-pin,