Page 1
GSM Module Installation Manual THANK YOU FOR VOTING TEXECOM GSM MODULE Installation Manual...
Page 2
The GSM module is only supported on control panels fitted with software version 3.0 or above. The GSM module can only be used as a modem if the data service is enabled by your network provider. Pay as you go tariffs generally do not provide this feature.
GSM Module as a backup for the Com300/2400). Installation Insert the GSM antenna in the SMB socket of the GSM module. Connect the RJ45 connector of the GSM-Com (CON 2) to the Headset socket of the GSM module.
Page 4
Attach the power cable (CON 1) of the GSM-Com to the GSM module. Connect the 7-way molex of the GSM-Com to COM2 on the control panel. The green power led on the GSM-Com and the orange led on the GSM module should now be lit.
Page 5
GSM Module Installation Manual Panel Configuration Before attempting to use the GSM module it must be correctly configured as follows: Enter “Engineers Programming” mode and select “UDL/Digi Options”, then select “Com Port Setup”. Ensure Com Port 2 is programmed as “GSM Module”.
Page 6
GSM Module Installation Manual SMS Control Commands Operation Command Example “5678 arm s” = arm all areas and report back Arm System ???? arm [areas][s] status. Part Arm System ???? parm (1/2/3)[s] “5678 parm 1” = part arm 1 all areas (no status) “5678 darm abcs”...
Page 7
A r e a t h a t c a u s e d t h e e v e n t Standards The GSM-Com and GSM Module conform to European Union (EU) Low Voltage Directive (LVD) 73/23/EEC (amended by 93/68/EEC) and Electro-Magnetic Compatibility (EMC) Directive 89/336/EEC (amended by 92/31/EEC and 93/68/EEC).
Need help?
Do you have a question about the GSM MODULE and is the answer not in the manual?
Questions and answers