Advertisement
Quick Links
Advertisement
Related Manuals for Texecom INS656-3
Summary of Contents for Texecom INS656-3
- Page 1 INSTALLATION INSTRUCTIONS Premier Elite Speech Module INS656-3...
- Page 2 Content 1.0 Introduction ..........................2.0 Hardware Identification ......................3.0 Specifications ........................4.0 Warranty ..........................INS656-3 2/13...
-
Page 3: Introduction
COM300. Only the first four Digi Channels are used by the Premier Elite Speech Module. The Premier Elite Speech Module is supported by the following Texecom control panels: Premier Elite all models factory built V3 and later, all models fitted with a DTMF decoder. - Page 4 The DTMF chip is located just below the digi pins and is identified with a green dot. The DTMF chip is located to the left of the main processor and is identified with a green dot. INS656-3 4/13...
- Page 5 PCB Layout and Connections The figure below shows the PCB layout of the Premier Elite Speech Module. INS656-3 5/13...
- Page 6 INS656-3 6/13...
- Page 7 Re-apply power to the system and proceed to the next section. Premier Elite Speech Module Locations Use the self-adhesive mounting posts to locate the Speech Module as shown. Premier Elite Small Polymer Housing (e.g. Live front ) mount to the rear of the housing INS656-3 7/13...
- Page 8 Premier Elite Large Polymer Housing (e.g. 24 & -W panels) mount to the inner wall of the housing Premier Elite Metal Housing (e.g. 48.88 & 168) mount inside the top of the housing. INS656-3 8/13...
- Page 9 1 or [REC2] for message 2 [REC3] for message 3 or [REC4] for message 4 Speak clearly into the microphone to record your message. During the recording process, the record indicator will illuminate. To stop the recording process, release the record buttons. The recording INS656-3 9/13...
- Page 10 Dial All Numbers (A shown on screen) Press Program ARC's Press then then (Program Digi) Press Using the Scroll key select Which ARC you wish to use Press and scroll to change the ARC protocol to Speech Module INS656-3 10/13...
- Page 11 If you need to change the defaults proceed as follows: ???? Enter the engineer code Press then (System Outputs). Press then for (Digi Channels). Press then use the to select the output type Press then use the to select the output Press then select the Areas INS656-3 11/13...
-
Page 12: Specifications
Current Consumption (Standby): Current Consumption (Active): Messages/Channels: Message Length: 10 Seconds each Dimensions: 52mm x 30mm x 10mm Packed Weight: Operating Temperature: -10°C (+14°F) to +50°C (+122°F) Storage Temperature: -20°C (-4°F) to +60°C (+140°F) Maximum Humidity: 95% non-condensing INS656-3 12/13... -
Page 13: Warranty
Texecom declares that this product complies with the requirements of the following directives: • 2004/108/EC EMC Directive • 2006/95/EC LVD Directive • 2011/65/EU RoHS Directive The product therefore meets all the requirements to enable it to be CE marked. WEEE Directive: 2012/19/EU (WEEE directive): Products marked with this symbol cannot be disposed of as unsorted municipal waste in the European Union.
Need help?
Do you have a question about the INS656-3 and is the answer not in the manual?
Questions and answers